[1000mp] Roofing Filter Installation

[Bob Main]

Thanks Mike, after installing the key-click mod this past weekend I think I 
can handle that.
73s
Bob
KB4CL

----- Original Message ----- 
From: "Mike Schatzberg" <cherokeehillfarm at earthlink.net>
To: "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
Sent: Tuesday, February 01, 2005 4:29 PM
Subject: Re: [1000mp] Roofing Filter Installation


> Bob:
>
> The connections do not require more than the removal of the bottom cover 
> of
> the radio to reach.
>
> Two thru the board holes in the Mark V audio board will provide ground and
> +5 volts to power the two stage low noise amplifier.
>
> These holes are easily reached, and full instructions are provided, to 
> allow
> the connections to the audio board, where the mod board is also 
> mechanically
> mounted.
>
> The earlier MP radio, already has pins in these two holes, and no 
> soldering
> is required for the install.
>
> Regards,
>
> Mike
> WB2AJI
> ----- Original Message ----- 
> From: "Bob Main" <bobmain1 at alltel.net>
> To: "MarkV" <1000mp at mailman.qth.net>
> Sent: Tuesday, February 01, 2005 4:10 PM
> Subject: [1000mp] Roofing Filter Installation
>
>
> I notice that on the INRAD site they say that on the Mark V that two 
> solder
> connections have to be made.  Can somebody tell me where these are at and
> what it consists of?
>
> Thanks,
> Bob
> KB4CL
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
>
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
>