[1000mp] Mark-V + Heil microphone = scanning the frequency

[Hans Remeeus]

Hello Rich,

Thanks for the info. Mike and Bill too for their reply.

The problems seems to occur when you connect the MIC GND with the COMMON 
GND.

- Connect the PTT-button between the COMMON GND and PTT.

- Connect the microphone element with the MIC GND and MIC. So the shield 
of the element is connected to the MIC GND instead of the COMMON GND, or 
both.


73,
Hans Remeeus (PA1HR)
http://www.remeeus.nl
Communication is about people, the rest is technology.



rmthorne at cox.net schreef:
> Hans:
> 
> Check the 8 pin connector going into the rig.  I had the same problem on a TS-850 once.  The Heil adapter had the pins short (inside the 8 pin mic connector) which caused the rig's vfo to go up in frequency.
> 
> Rich - N5ZC
> 
>> From: Hans Remeeus <hans at remeeus.nl>
>> Date: 2005/11/30 Wed PM 02:08:46 EST
>> To: All about Yaesu 1000mp <1000mp at mailman.qth.net>
>> Subject: [1000mp] Mark-V + Heil microphone = scanning the frequency
>>
>> Somebody else who uses the Mark-V with a Heil microphone and wonders why 
>> the rig's VFO starts scanning the frequency?
>>
>> -- 
>>
>> 73,
>> Hans Remeeus (PA1HR)
>> http://www.remeeus.nl
>> Communication is about people, the rest is technology.
>>