[1000mp] QUADRA question

[Dennis]

Hi John,

Thanks for the reply, the only one I got by the way.  I go through the same
start up as you do.  I get the error message #1008 when I key up the MARK-V
in the "OPERATE MODE".  What I mean is if I just use the tuner on the QUADRA
with the operate off it tunes my antenna, than I switch to operate on the
QUADRA.  When I key the MARK-V again with the QUADRA in operate mode I get
the #1008 error.  I have called YAESU (twice) and NO help.  Everything works
fine on all other bands.

Thanks for your reply,
Dennis AB8NI


----- Original Message ----- 
From: <JTrager316@aol.com>
To: <1000mp@mailman.qth.net>
Sent: Sunday, July 20, 2003 2:13 AM
Subject: Re: [1000mp] QUADRA question


> In a message dated 7/15/2003 11:40:21 AM Eastern Daylight Time,
> roofus@sbcglobal.net writes:
>
> > Hi Gang,
> >
> > I have just received a QUADRA and it is working great except for 6
meters.
> > The set up is, FT1000MP MARK-V, FTV-1000 transverter and than the
VL-1000
> > QUADRA.  Band switching and everything works until I get to 6 meters
when I get
> > this error message #1008 (Conflicting Band Selection).  It works in the
> > through mode but when I switch to operate I get the error message.  The
> > transverter is set to 50-52, the MARK-V is set to 28.125 and the QUADRA
shows 50 MHz.
> > I have tried setting the MARK-V to show 50 MHz via the 3-3 menu but
still
> > have the same error message.  I have checked and re-checked the
connections and
> > all seem to be in order.  I called YAESU and they said DUH.
> >
> > Thanks,
> > Dennis AB8NI
> >
>
> Dennis,
>
> Have you figured out what is going on?
>
> I have your exact same setup, but my Mark-V/Quadra/FTV-1000 works fine.  I
> power up the FP-29 Power Supply, the Mark-V, Quadra, and then the
FTV-1000.  Set
> the frequency on the Mark-V to 28.00000Mhz.  Go to Menu 3-3 and set it for
50
> (Mhz).  I then can enter say 28.125 to set the equipment up for 50.125Mhz,
> and everything works fine... and you say when you place the Quadra into
OPERATE,
> you get an #1008 error message?
>
>
>
> John
> N2KBE
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment.  Attachments are not allowed.  To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>