[1000mp] QUADRA question

[1000mp@mailman.qth.net]

In a message dated 7/15/2003 11:40:21 AM Eastern Daylight Time, 
roofus@sbcglobal.net writes:

> Hi Gang,
> 
> I have just received a QUADRA and it is working great except for 6 meters.  
> The set up is, FT1000MP MARK-V, FTV-1000 transverter and than the VL-1000 
> QUADRA.  Band switching and everything works until I get to 6 meters when I get 
> this error message #1008 (Conflicting Band Selection).  It works in the 
> through mode but when I switch to operate I get the error message.  The 
> transverter is set to 50-52, the MARK-V is set to 28.125 and the QUADRA shows 50 MHz.  
> I have tried setting the MARK-V to show 50 MHz via the 3-3 menu but still 
> have the same error message.  I have checked and re-checked the connections and 
> all seem to be in order.  I called YAESU and they said DUH.
> 
> Thanks,
> Dennis AB8NI
> 

Dennis,

Have you figured out what is going on?

I have your exact same setup, but my Mark-V/Quadra/FTV-1000 works fine.  I 
power up the FP-29 Power Supply, the Mark-V, Quadra, and then the FTV-1000.  Set 
the frequency on the Mark-V to 28.00000Mhz.  Go to Menu 3-3 and set it for 50 
(Mhz).  I then can enter say 28.125 to set the equipment up for 50.125Mhz, 
and everything works fine... and you say when you place the Quadra into OPERATE, 
you get an #1008 error message?



John
N2KBE


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---