[1000mp] MkV Amp interfacing questions

Sat, 2 Nov 2002 16:51:26 -0800

Lou Yaesu sent me one for no charge.  Give them a call Monday or send them
an E-mail

Rod WC7N

----- Original Message -----
From: "lhlousek" <[email protected]>
To: <[email protected]>
Sent: Saturday, November 02, 2002 4:40 PM
Subject: [1000mp] MkV Amp interfacing questions

> The Band Data jack does not seem to be the typical 8 pin DIN connector.
Does anybody know the type designation and
> where I can get the proper mating plug?
>
> The manual states (page 12) that pin 8 of the Band Data jack can be used
as a TX Inhibit control and must be pulled low
> to enable the MkV.  Nothing currently pulls this line low so it would
appear it must first be pulled high to disable TX,
> perhaps with a resistor of a few K from the 13V on pin 1.  Correct?
>
> Lou W7DZN
>
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>