[1000mp] MkV Amp interfacing questions

Sat, 2 Nov 2002 23:02:38 -0500

Yaesu charged me a lot of postage for sending me the "free" plug, which
should have been included with the radio!
    Look in the archives.  You will find the way to buy a plug for less
than the "free" Yaesu plug.  ...the plug is not standard.  Kenwood also
uses the plug.
        73   Mac   N8TT
J. Mc Laughlin  -  Michigan USA
Home:  [email protected]
Office:  [email protected]
----- Original Message -----
From: "WC7N" <[email protected]>
To: <[email protected]>
Sent: Saturday, November 02, 2002 7:51 PM
Subject: Re: [1000mp] MkV Amp interfacing questions


> Lou Yaesu sent me one for no charge.  Give them a call Monday or send
them
> an E-mail
>
> Rod WC7N
>
> ----- Original Message -----
> From: "lhlousek" <[email protected]>
> To: <[email protected]>
> Sent: Saturday, November 02, 2002 4:40 PM
> Subject: [1000mp] MkV Amp interfacing questions
>
>
> > The Band Data jack does not seem to be the typical 8 pin DIN
connector.
> Does anybody know the type designation and
> > where I can get the proper mating plug?
> >
> > The manual states (page 12) that pin 8 of the Band Data jack can be
used
> as a TX Inhibit control and must be pulled low
> > to enable the MkV.  Nothing currently pulls this line low so it
would
> appear it must first be pulled high to disable TX,
> > perhaps with a resistor of a few K from the 13V on pin 1.  Correct?
> >
> > Lou W7DZN
> >
> >
> > _______________________________________________
> > List Moderator: Richard Lubash N1VXW
> > 1000mp mailing list
> > [email protected]
> > To Change Options or Unsubscribe:
> > http://mailman.qth.net/mailman/listinfo/1000mp
> >
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp