[1000mp] FT-1000MP Update New Info - Scanning Between Frequencies P1-P9

Mon, 03 Jun 2002 10:02:49 -0400

Bill, I went back to my manual and found the reference that you described.  It
even was highlighted, but I must have forgotten about it.  I actually use the
memories little, if at all, and confusion may have arisen from the occasional
resets that I have had to invoke because of tuner misbehavior problems here.
Nevertheless, the involvement of the FAST key with memory visibility is a far
cry from intuitive.

73, Joe

WD8ARZ wrote:

> Your Welcome Bruce, I love the sharing nature of this group!
>
> Latest tip update about P1-P9 Memories:
>
> While playing on my MP after reposting the previous message about the MP
> memories and the P1-P9 Scanning features in particular.... I noted that I
> could not get my P1-P9 memories to display at all, with Fast enabled or
> disabled. Wow, was I surprised!!
>
> Turns out that with the Mem Group button enabled, the P1-P9 memories will
> not be selectable, even with data stored in them. When the Mem Group button
> is active, you will see GROUP lighted under the Ant A B section of the
> display panel. Turn that off, and the P1-P9 Scanning memories are available
> again.
>
> Even after all this time, still learning stuff on this great radio! Hi Hi
>
> 73 from Bill - WD8ARZ
> [email protected]
>
> ----- Original Message -----
> From: <[email protected]>
> To: <[email protected]>
> Sent: Thursday, May 30, 2002 11:33
> Subject: Re: [1000mp] FT-1000MP Tip of the Month - Scanning Between
> Frequencies - Repost
>
> > Great tip Bill. That explains why "My memories work the same with either
> > setting of the FAST button."  In fact they do not. I just had frequencies
> in
> > all of the memories tested so I did not see any difference.
> >
> > Bruce  AA4Z
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp