[Yaesu] FT-100 D "SPL"

[Dypete at aol.com]

Hello all and thanks for the time.......
 
I've been attempting to program an FT-100 D. I am selecting the frequency,  
mode, tone (for 2m), etc within the 1-20 memory slots.
I was able to program a number of frequencies until my 2m frequency. I did  
everything as all the HF frequencies and the attempted to store it in a  
memory. It stored it with "SPL" active.
I went back to the vfo, and the vfo still had the rpt offset "-".
I attempted to store it again, and the same thing occurred.
Not only did it store that memory with "SPL" but all memory slots now  have 
"SPL".
I have attempted to "remove" the active "SPL" choice in the menu but to no  
avail.
 
Any insight into properly programming my freq. choices and the storing  
them into memory would be greatly appreciated!
 
PS.....
How do I have both VFO A and B as choice AT THE SAME TIME?  Only have VFO 
"A" available.
 
Thanks!
Pete
KB2DY   
 
Peter  Giacopelli
"Carpe Diem" 
"Seize the day"
"It's OK to think about what  you want(ed) to do but it's time to do what 
you were meant to do."
"Life can  only be understood backwards; but it must be lived forwards" - 
Søren  Kierkegaard
"Nature does nothing uselessly" Aristotle
"Improvise, Adapt,  Overcome" movie " Heartbreak Ridge"
"Remember, Progress not  perfection!"
“Success is not something to wait for : it is something to work  for.”
"The best way to help yourself is to help someone else"