[Wswss] Re: [Sbms] N female chassis or bulk head conector, is there a tool?

[wb6tza at socal.rr.com]

there is a chassis punch, single or double flat.  they are NOT cheap, from 
Greenelee.  Also, use carefully, they break the shaft pretty easily if the 
exact model uses a 1/4 inch shaft

Robin


----- Original Message ----- 
From: <n3izn at aol.com>
To: <microwave at lists.valinet.com>
Cc: <sbms at ham-radio.com>; <wswss at mailman.qth.net>; 
<PNWVHFS at googlegroups.com>
Sent: Tuesday, September 09, 2008 09:17
Subject: [Sbms] N female chassis or bulk head conector, is there a tool?


> You know those N type female bulkhead connectors that have 2 opposite 
> sides flat. They fit right into a chassis and then they can be turned 
> around? Is there a special tool or punch available at a decent cost to 
> make that hole? Or does just every one use a round hole and tighten it 
> down and be extra careful taking the connector on and off.
>
> Thanks
>
>
> ?
>
> _______________________________________________
> Sbms mailing list
> Sbms at lists.altadena.net
> http://lists.altadena.net/mailman/listinfo/sbms