[WSWSS] FS

[W7PW]

I have the following for sale. Prices are postpaid in the lower 
48...shipping to other locations TBD.

1) California Microwave 3456MHz filter with isolators at both input and 
output. Commericial 6-pole filter retuned on a network analyzer for 
Amateur Radio frequencies: 3.2db insertion loss, 24.9db return loss, 
10db BW about 50MHz. $40.00

2) Two Narda model 4323-3 3-port power dividers for 2-6GHz. Low power 
(probably a watt or less). I'll include an SMA load for each divider to 
make it easier to use as a two-port device. $15.00 each

3) Three SPDT SMA relays, two Teledyne CS33S10's and one Wavecom 
8020-A0-A1D-4C0. All have 28-volt coils. $15.00 each

4) RLC Electronics SP4P SMA relay model S-3228. Cylindrical 
configuration, about 1.5" diameter and 1.6" long. Has a flange on one 
end for panel mounting. Also has some sort of capability to drive 
indicators to show which port is switched. 28-volt coils. $25.00

5) RLC Electronics S-2886 SPDT "N" relay. Unit is marked "15VDC" for 
coil voltage. $25.00

6) Minicircuits Labs ZAPD-1 900MHz 2-port power divider. Matched power 
rating 10 watts. "N" connectors at all ports. $12.50

7) Minicircuits Labs ZC4PD-900 900MHz 4-port power divider. Matched 
power rating 10 watts. SMA connectors at all ports. $12.50

8) Minicircuits Labs Z998HPD-896-1 8-port power divider. Matched power 
rating not known but is probably 10-watts. TNC connectors at all ports. 
$10.00

9) Radio Shack audio DSP unit, model 21-543. Very good condition. No 
power supply included (requires 12VDC at a few hundred milliamps). $25.00

10) Ten 100-watt (with heat-sinking) 50-ohm loads, food to at least 
2.4GHz. Two hole flange-mount with solder-tab for RF connection. Holes 
are the same spacing as an "N" connector, so they can mount directly to 
a low-profile "N" chassis connector. I've tested these loads in a lab 
and they are capable of taking 150+ watts for several minutes with a 
proper heat-sink. $3.00 each

11) Twenty 50-ohm loads like #10, but rated for 10-watts. Single hole 
flange mount. These loads have been tested in a lab at 20-watt power 
levels (with good heat sink) and do not fail (Failure finally comes at 
levels approaching 50-watts). $1.00 each

12) Mitsubishi M-67773 18-watt 900MHz linear power amplifier module. 
This module was used in the DEMI 3320PA-series amplifiers. Inlcudes DEMI 
docs that came with the 3320PA. $40.00

13) Two Motorola CV-2800 900MHz PA cavities, with used but good 3CX400U7 
tubes, with modification documentation. $40.00 each

Thanks for looking,

Jack, W7PW