[TVARC] Zero Points in N1MM+

[K2PS Pete Stafford]

Well, worse comes to worse, after the contest you can replace RTTY (or DIG)
with CW in the Cabrillo file.

73, Pete, K2PS

-----Original Message-----
From: tvarc-bounces at mailman.qth.net [mailto:tvarc-bounces at mailman.qth.net]
On Behalf Of Frank M
Sent: Sunday, May 26, 2019 8:34 AM
To: villages reflector
Subject: [TVARC] Zero Points in N1MM+

Problem seems to have been found but still no solution.
Operating N1MM+ with FLDIGI in CW mode as digital interface. Using N1MM+
macros. Rig (IC-7300) is in USB Digital. Correct contest loaded and verified
in N1MM+. Macros generate good CW through rig - no problems making CW
contacts. Each QSO correctly enters valid data into the N1MM+ log but points
are zero. 
Problem: N1MM+ shows contact mode as RTTY!! No matter what I do in N1MM+
setup, mode control etc, i can not get N1MM+ to show contact mode as CW!!!!
Note: it would probably work right if I had the time to set up to operate
the rig in real CW but have not done it yet. I have used the digital set up
before but this time it just is not working right. 
Think I will order a RIGblaster!!!!

Frank KA1AF 

Sent from my iPhone
______________________________________________________________
TVARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/tvarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TVARC at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html