[TVARC] Zero Points in N1MM+

[Frank M]

Problem seems to have been found but still no solution.
Operating N1MM+ with FLDIGI in CW mode as digital interface. Using N1MM+ macros. Rig (IC-7300) is in USB Digital. Correct contest loaded and verified in N1MM+. Macros generate good CW through rig - no problems making CW contacts. Each QSO correctly enters valid data into the N1MM+ log but points are zero. 
Problem: N1MM+ shows contact mode as RTTY!! No matter what I do in N1MM+ setup, mode control etc, i can not get N1MM+ to show contact mode as CW!!!!
Note: it would probably work right if I had the time to set up to operate the rig in real CW but have not done it yet. I have used the digital set up before but this time it just is not working right. 
Think I will order a RIGblaster!!!!

Frank KA1AF 

Sent from my iPhone