[TrunkCom] Clearwater. Florida

[wpascanrec@wpascanner.com]

On 28 May 2002, at 6:01, JERRY NONE wrote:

> For an EDACS system to work on a Pro-92B, you have to
> do the following:

> 2.) Program the system into the bank and only that
> system.  You cannot program in EDACS and LTR, EDACS
> and Motorola

Correct.

> EDACS and CONVENTIONAL.

Incorrect. I have the local paging rebroadcast and all the NSPAC ITAC 
channels programmed into the same bank as my EDACS system. Works 
quite well.

>  You can only
> program in one EDACS system into the bank. 
> Programming in two EDACS systems into a bank will not
> make the scanner scan properly.

Correct

> 3 to 5

Correct.

> 6.) Lockout all remaining channels.

No need to lock out channels. When scanning the channels are selected 
based on the LCN's, then scanning of the conventional if no active TG's in 
your scan list are active.

> 8.) As, for the talkgroups, use onlyh the talkgroups
> listed under the Dec 

Correct. Pro 92/2067 ONLY use decimal NOT Unidens AFS format.

> What you stated as a talk group, 02-231, actuals shows
> you what logic channel, talk group 231 is on.  In this
> example, talk group 231 is on logic channel 2.

No, that is not correct.

02 is the Agency of the active group: ie: 02 may be law enforcement, 03 
fire, 04 ems, 05 DPW, 06 may be another law enforcement.

All of this is signifigant in translating from AFS (02-xxx) to decimal 

Valid Agencies are 00 to 15. Valid fleets are 000 to 157 which yields 2047 
possible talkgroups.

The full 02-231 is invalid for EDACS.It has no correlation to the LCN at all.