[TheForge] Hammered Sheet Metal Question

[Peter Fels & Phoebe Palmer]

Working a sheet with a small air riveting hammer over junk plywood
goes awfully fast if cost is a big consideration.

On Mar 27, 2014, at 6:15 AM, Dave Mudge wrote:

Good Morning Group,
I am looking for a source for pre-hammered sheet aluminum (or even
stainless)
about in the 18 gauge to 20 gauge thickness. It's for a possible project
through
the shop where I work. The client's budget probably wouldn't cover hand
hammering or
even powerhammer working the sheet.

thanks,
dave m
-- 











NOTICE: Due to Presidential Executive Orders, the National Security Agency
may have read this email without warning, warrant, or notice. They may do
this without any judicial or legislative oversight. You have no recourse
nor protection.
______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.shutterfly.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html