[TheForge] Drilling angles etc

[Peter Hirst]

Concrete is the easiest material in the world to angle drill.  That is if 
you are talking drilling, an inch or two diameter.  Start at a right angle 
and tilt it over in the first inch or so as you go, then patch around the 
post after setting .  Even easier:  set the post THEN pour the mud areound 
it.


----- Original Message ----- 
From: "Woolley" <wjec1 at verizon.net>
To: "Blacksmithing List Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Wednesday, March 11, 2009 9:27 AM
Subject: [TheForge] Drilling angles etc


> Hello,
>
> While we are on the subject of drilling angles....  I have seen posts
> set in concrete at an angle. I have never had to set one like that but
> was curious how I would do it if I had to. Any one ever do this?
>
> Regards,
> Bill Woolley
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>