[TheForge] kaowool

[terry l. ridder]

hello mike;


On Tue, 24 Feb 2009, GRAF wrote:

> OR
> you could just by some insulation board.
>

well DUH!!!!

i have several sheets of kaowool board.

too much morphine, too much morphine :-(

>
> Mike Graf
>
> terry l. ridder wrote:
>> hello;
>> 
>> i need to protect an area from heat while some work is done.
>> i have two rolls of kaowool 8lb density blanket. i am thinking
>> of using this as the basis of the protection. it needs a
>> stiffener applied to it and then a coat of itc-100 over the
>> stiffener.
>> 
>> i need to stiffen the kaowool enough so that a piece 4ft square
>> would stand up on its own.
>> 
>> once i have the kaowool stiffened and coated with itc-100, i plan
>> on placing it in a stainless steel channel frame. the frame will
>> not crush or firmly hold the kaowool. the frame is just to provide
>> minimal support. the frame is more to protect the edges of the
>> kaowool blanket from damage when moved.
>> 
>> i have been unable to find a stiffener to use on the kaowool.
>> 
>> any suggestions, hints, comments, flames are most welcome.
>> 
>>

-- 
terry l. ridder ><>