[TheForge] RE: Tarnished brass

[Peter Hirst]

Nev r dull
----- Original Message ----- 
From: "Richard Rozinski" <rrozinski at cox.net>
To: <munlaw2 at hcsmail.com>; "Blacksmithing List Sponsored by ABANA" 
<theforge at mailman.qth.net>
Sent: Thursday, October 02, 2008 3:57 PM
Subject: Re: [TheForge] RE: Tarnished brass


> Even though it says right on the instructions "not for use on Brass", 
> I've used "TARN-X"  to remove the tarnish from  my own  raised brass 
> sheet forms  that I use in my  sculpture.   I did wash it off with  lots 
> of cold water immediately  with no  adverse  reactions. Its been  a while 
> since I did this and I have seen no problems with the metal at  all.  I've 
> sealed the brass  with a clear sealant and  the brass is  still Ok.
>
> Rich
>
>
> On Oct 2, 2008, at 12:27 PM, Ron Childers wrote:
>
>>
>> What is the quickest way to clean tarnish off a brass 90mm cannon  shell? 
>> I
>> made a bell out of it and would like to shine it up, but Brasso hardly
>> touched it.
>>
>> Ron C
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> ************************************************************************************
>> This footnote confirms that this email message has been scanned by
>> PineApp Mail-SeCure for the presence of malicious code, vandals & 
>> computer viruses.
>> ************************************************************************************
>>
>>
>>
>> _______________________________________________
>> Manage membership or unsubscribe at:
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  blacksmithblacksmith at hotmail.com
>> password:  anvil
>> ___________
>>
>>
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>