[TheForge] RE: Tarnished brass

[Richard Rozinski]

Even though it says right on the instructions "not for use on Brass",   
I've used "TARN-X"  to remove the tarnish from  my own  raised brass  
sheet forms  that I use in my  sculpture.   I did wash it off with  
lots of cold water immediately  with no  adverse  reactions. Its been  
a while since I did this and I have seen no problems with the metal at  
all.  I've  sealed the brass  with a clear sealant and  the brass is  
still Ok.

Rich


On Oct 2, 2008, at 12:27 PM, Ron Childers wrote:

>
> What is the quickest way to clean tarnish off a brass 90mm cannon  
> shell? I
> made a bell out of it and would like to shine it up, but Brasso hardly
> touched it.
>
> Ron C
>
>
>
>
>
>
>
>
>
> ************************************************************************************
> This footnote confirms that this email message has been scanned by
> PineApp Mail-SeCure for the presence of malicious code, vandals &  
> computer viruses.
> ************************************************************************************
>
>
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>