[TheForge] scraper

[Lon Humphrey]

scraper...make it out of a old file like a hunting knife with no 
edge...thats what we use to scrape babbit bearings and fiber bearings


----- Original Message ----- 
From: "Andrew Vida" <osan at netlabs.net>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Saturday, March 01, 2008 7:35 PM
Subject: Re: [TheForge] scraper


>A properly made scraper in the right hands can remove metal by the 
>*millionth* of an inch.
>
> schade at acegroup.cc wrote:
>>
>> On Mar 1, 2008, at 10:19 AM, Bob Smolen wrote:
>>
>>> Is there a practial way to make a scraper to remove a few thousandts 
>>> from a
>>> flat surface. I am tired of used abraive paper. Alternatively, where can
>>> such a tool be purchased?
>>> Thanks,
>>> Bob
>>>
>>> ____________
>>
>>
>>
>> http://gfish.livejournal.com/187606.html
>>
>> _______________________________________________
>> Manage membership or unsubscribe at:
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  blacksmithblacksmith at hotmail.com
>> password:  anvil
>> ___________
>>
>>
>
> -- 
>
> -Andy V.
>
> no .sig
> go .fig
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>