[TheForge] ON TOPIC: Partitioning Building for smith - WAS: Guns/Politics / BS

[Grover.Richardson at gtri.gatech.edu]

That makes most excellent sense.  As well, many of the real
professionals around here put all their machines on wheels.  That way
they can be moved to where they are needed, or could be moved out of the
way.  If you choose your wheels correctly, you could temporarily move
the equipment out of the shop too.

Just now got back to work and found your question.  

Also I like the plastic covered flexible waterproof wire tubing that I
use at my side work.  Flexible waterproof conduit.  If something hot
falls, then the plastic melts and smells.  The metal will try to sink
the heat away from the wires until you smell it and pick it back up<G>.

All the best. 

~>-----Original Message-----
~>From: theforge-bounces at mailman.qth.net 
~>[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Andrew Vida
~>Sent: Friday, December 21, 2007 1:40 PM
~>To: Sponsored by ABANA
~>Subject: Re: [TheForge] ON TOPIC: Partitioning Building for 
~>smith - WAS: Guns/Politics / BS
~>
~>Oh... another thing: I'm considering putting the doors offset 
~>to one side.  I want doors on the gable ends to accommodate a 
~>full trailer rig to enter on one side and exit the other.  
~>Offsetting gives more static room on one side... does this 
~>not make sense?  As so:
~>
~>
~>                              /\
~>                             /  \
~>                            /    \
~>                           /      \
~>                          /________\
~>                         |          |
~>                         |          |
~>                         |       __ |
~>                         |      |  ||
~>                         |______|  ||
~>
~>Grover.Richardson at gtri.gatech.edu wrote:
~>> A very good alternative is excess pressure in the protected areas.
~>> Since the protected areas are enclosed (the smithy likely will have 
~>> the doors open for many reasons, they are easy to pressurize.
~>> 
~>> ~>-----Original Message-----
~>> ~>From: theforge-bounces at mailman.qth.net 
~>> ~>[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Bob Willman
~>> ~>Sent: Friday, December 21, 2007 10:48 AM
~>> ~>To: 'Sponsored by ABANA'
~>> ~>Subject: RE: [TheForge] ON TOPIC: Partitioning Building 
~>for ~>smith 
~>> - WAS: Guns/ Politics / BS ~>
~>_______________________________________________
~>Manage membership or unsubscribe at:
~>http://mailman.qth.net/mailman/listinfo/theforge
~>theforge mail list group photo site is
~>http://www.photoaccess.com
~>Login:  blacksmithblacksmith at hotmail.com
~>password:  anvil
~>___________
~>
~>
~>