[TheForge] MIG Welders

[Lon Humphrey]

it will not burn as hot as the oxygen mix for this i would spend the xtra 
money....i used to weld on large pressure vessels we miged all the fittings 
in with that gas co2 argon and o2

----- Original Message ----- 
From: "Woolley" <wjec at verizon.net>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Tuesday, May 22, 2007 10:21 AM
Subject: Re: [TheForge] MIG Welders


>I use argon. It's fine and cheaper.
>
>
>
>
>
>
> Mark A. Pesetsky wrote:
>> 1/2" plate is the thickest welds that I will have. Not going to buy a
>> stick welder just for this. Will do multiple passes I guess....But the
>> gas addition was needed I know that and have been meaning to do it, just
>> didn't have the need like I do now. Just a matter of getting aquainted
>> with the new set up...
>>
>> Thanks
>> Mark
>>
>>
>> half inch plate?? multiple pass with a gas mixed with a smaill about of
>> oxygen so you can spray it on ....OR stick weld it
>>
>> _______________________________________________
>> Manage membership or unsubscribe at:
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  blacksmithblacksmith at hotmail.com
>> password:  anvil
>> ___________
>>
>>
>>
>>
>>
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>