[TheForge] Swage block stands

[Jerry Smith]

Great Resource!

I haven't look at the whole thing, but maybe tomorrow
I will.

Thanks,

Jerry
--- Roger R Degner <rog781 at means.net> wrote:

> Seen pictures of stands made from angle iron
> Sat in frame when flat and had a dropped center
> frame to allow it to sit
> there on edge at the same height as when flat
> 
> Not sure if there are pictures at www.iforgeiron.com
> in the blue print
> section but there are a lot of nice plans there with
> plenty of pictures.
> Hoffi put hundred pictures or more.
> 
> Roger R Degner
> 
> 
> I have one of those swage blocks that doesn't have
> the rotating ends on. I
> was think of welding up a stand from old bed rails,
> anyone have any ideas of
> doing this sort thing?
> 
> Jerry
> _______________________________________________
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
>