[TheForge] Burner angle

[Ron Childers]

Harry, I forgot to tell you- Google "freon tank forge" and look at Ron
Riel's site on propane forges


Ron C

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Harry
Sent: Friday, July 13, 2007 11:54 AM
To: Sponsored by ABANA
Subject: RE: [TheForge] Burner angle

Hi Mikey,

   That is a good idea. Make it even more versatile. I am liking it.

Harry

On Fri, 13 Jul 2007 07:33:09 -0700, "Kathy" <keporter at comcast.net> said:
> Harry,
> Straight or swirl; it's really not an either or proposition. Why not
> install two
> different burner portals; one for swirl, and the other for spot heating?
> By
> moving the burner back and forth between them, you can use either heating
> scheme. A plug of ceramic fiber, piece of firebrick, or what have you may
> also
> be moved back and forth to prevent heat loss through the unused port.
> Mikey
> 
> -----Original Message-----
> From: theforge-bounces at mailman.qth.net
> [mailto:theforge-bounces at mailman.qth.net]
> On Behalf Of IowaHarry
> Sent: Thursday, July 12, 2007 12:37 PM
> To: The Forge
> Subject: [TheForge] Burner angle
> 
> Hi All,
> 
>     I am putting together a small propane forge using a disposable freon 
> can. I have made a hole just above the center weld. For alignment what 
> should I be looking for? I can add more burners later as needed but to 
> start with I am mounting just one. Should I have it blast down dead 
> center or angle it to get a swirling effect? I intend to mount a socket 
> I can set the burner in so when finished I can pull the burner out.
> 
> Please pardon as I am sure this is an oft repeated question. If this is 
> info available online, a link would be just grand.
> 
> thanks, Harry
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
-- 
  Harry
  iowaharry at fastmail.net

-- 
http://www.fastmail.fm - Accessible with your email software
                          or over the web

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________