[TheForge] Coal Forges - lets try this again

[Grant Marcoux]

1/4"  would be more than enough.  You may want to consider mounting the
forge on HEAVY locking casters for ease of movement.

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net]On Behalf Of John Husvar
Sent: Tuesday, July 03, 2007 7:18 AM
To: theforge ABANA
Subject: Re: [TheForge] Coal Forges - lets try this again





On 7/3/07 8:35 AM, "Jerry Smith" <jerry_smith at anvilsandinkstudios.com>
wrote:

> Bruce,
>
> I wqant to have a good forge, a well built forge. I
> have the money to spend, but your right some of the
> prices are too high!
>
> Now I am looking for a decent heavy fire poy, then buy
> the sheet steel.
>
> What grade of 1/2 inch steel for the table should I
> buy?
>

Just wondering: Why would you want to use 1/2 inch plate for the table? It
shouldn't experience any significant heating and would be heavy as all Hell
to move around.

I can agree with wanting to do it only once, but that seems like major
overkill. :)

1/4-inch should be plenty strong enough for a forge table unless you're
planning to use it as an anvil too. :)

Hell, seems to me 1/8-inch is plenty if you weld a couple of 1-1/4 X 1-1/4 X
1/8 angles under it for stiffeners. Something like bedframe angle would
work.

You're just going to be holding up some coal and maybe a few pairs of tongs,
no?


_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________

No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.476 / Virus Database: 269.9.14/884 - Release Date: 7/2/2007
3:35 PM

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.476 / Virus Database: 269.9.14/884 - Release Date: 7/2/2007
3:35 PM