[TheForge] hammer dies

[Larry Brown]

End edges or front and back? End edges I would line up one side, front and 
back adjust with shims
Try not to let it live up to its name
L Brown

At 11:07 AM 4/14/2007 -0400, you wrote:
>Question in regards to hammer dies and general info on my 50 pound hammer
>
>I just recently bought a 50 pound little giant hammer it seems the dies 
>aren't parallel to one another
>
>I pulled down the top die and from side to side they are out of parallel 
>by about ¼ of a inch
>
>My question is how do I tell if they are supposed to be like that or do I 
>have a bigger problem?
>
>Since im a new hammer owner any tips on care and feeding of this beast ..I 
>think im going to name it the "skull crusher"