[TheForge] Sheet metal bender

[George Rousis]

i would imagine a slip roll would do the trick...
12 times pi
for the width of material
use construction paper to figure out the elbows...

where are you located??



On Sep 18, 2006, at 10:17 PM, Daniel Kretchmar wrote:

> Greetings,
>           I need 12" diameter chimmey pipe for my new side draft  
> hood.  I looked into menards.  They have galvanized 12"  24 gauge  
> chimney.  I looked into having some custom stuff made but it's too  
> costly.....so the next question is.....can I make it myself?
>
> What kind of bender would I need to make 12" diameter pipe/tubing  
> out of 24 gauge stainless steel?  I want to make it in 2 ft  
> sections. which means investing in a crimper a bender.....and what  
> about elbows?  I'll need two 90 degree elbows.  How will I make them?
>
> Advice is appreciated
>
> Dan
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>