[TheForge] RR Spike tongs

[Rob Fertner]

Just off the top of my head, try the Anvilfire site. Look at the iforge
projects. Now, what I do for spike tongs is to take a pair of nippers that
I've picked up cheap at an estate sale and convert them. I like the ones
that have one jaw blunt edged and the opposite one sharp. 
The sharp edged side I straighten out and then split. I forge it into two
tines or fingers. The spike head is asymmetrical, one side is slightly
longer. I place the long side down into the curve of the blunt jaw and then
the two fingers are forged down on each side of the spike. Also, the blunt
jaw curve is tightened up so you have a secure grip of the spike head. I
hope that makes sense.

Rob

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Kenny O.
Sent: Sunday, September 10, 2006 6:12 PM
To: Sponsored by ABANA
Subject: [TheForge] RR Spike tongs

I saw a pair of these some where on the super highway, does any one 
recall how to make these or seeing them on the Internet some where?
I  have acquired many lbs. of  spikes.
 Thank You One and All
 K.O.
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________