[TheForge] lp forge

[Ron Childers]

I lined the bottom with gas heater ceramic and it melted so the 1900* fiber
board probably will also.

Ron C  

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Steve Smith
Sent: Tuesday, June 27, 2006 6:40 AM
To: Sponsored by ABANA
Subject: Re: [TheForge] lp forge

1" shelf will take a few minutes longer to get up to heat, not a big 
deal. I think your fiber board will melt or at least sag though.

Steve

Kenny O. wrote:

> hello all
> I am building the lp forge from the burners and forges book, The specs 
> call for 1/2" -3/4" kiln shelf.
> I picked up a 1" shelf for a deal. I found that the shipping was cost 
> prohibitive for the shelf , so I settled for
> not the right thing, but the right price.
> Also there is no one around here with 2300 deg. fiber board, only 1900 
> backer board. ( for the ends or doors),
> questions
> 1. is this 1" shelf a bad thing.?
> 2. is the 1900 deg bb the totally wrong deal?
> 
> Thanks for the feedback
> Kenny 0
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________