[TheForge] Powermig 110

[mpaietta]

       I had a problem with a Lincoln that I borrowed where
the wire would not    feed or would stutter. it was a 125.
What I found out was the wing nut would    tighten as I used
it and would lock down the spool. There was a key slot in   
the spool stud, so I took some wire bent it around the wing
nut the took both    ends of the wire and pushed it in the
key slot. This kept the wing nut from    tightening. May or
may not be your problem.
   Good luck
   Martin
>                                  Hi Folks,
>    
>            Just bought a used mig for cheap.  The wire
> won't feed, think
>    that there is a kink in the wire inside the hose.  The
>    motor turns and
>    pushes wire, but it is jammed inside and won't advance.
>  My questions
>    are these:  One, what size wire does the Powermig 110
> take?  And, does
>                  anyone have suggestions on how to remedy
> this?
> 
> 
>                                   Thanks,
> 
> 
>                                   Chris K.
> 
>    It is I who formed the blacksmith,
>    who fans the flame into a fire and
>    fashions a weapon fit for it's work.
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
>    ___________
> 
>