[TheForge] Re: Odd size stock

[Ron Childers]

Bill, does the bar have to be one 12' length or shorter sections? 

-----Original Message-----
From: roger olsen [mailto:erik at methow.com] 
Sent: Wednesday, April 05, 2006 7:08 AM
To: munlaw2 at hcsmail.com; Sponsored by ABANA
Subject: Re: [TheForge] Re: Odd size stock

is there a metric dimension that would answer your needs?  are you close to 
the Canadian border?

otherwise I would just clamp it to a table and walk a grinder down it 2 
maybe three times followed by a sander,  check with calipers.

you did not say what this is for so don't know how it  has to look.


----- Original Message ----- 
From: "Ron Childers" <munlaw2 at hcsmail.com>
To: "'Sponsored by ABANA'" <theforge at mailman.qth.net>
Sent: Wednesday, April 05, 2006 3:40 AM
Subject: RE: [TheForge] Re: Odd size stock


Get Skeeter to do it 4 u. I'll look in my junk yard. RC

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Patty Draper/Bill
Robertson
Sent: Tuesday, April 04, 2006 8:20 PM
To: Sponsored by ABANA
Subject: [TheForge] Re: Odd size stock

Does anyone know a supplier that carries really off size stock.  I have
looked for  7/16 flat stock in 3/4  to 1' widths and have been unsuccessful
with the suppliers I have contacted.  And, no, I really don't want to forge
12 feet of it down.  Bill

_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________



_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________