[TheForge] Beverly shear sharpening?

[Larry and Pat Brown]

I believe this is them, if not I can look for the receipt for the parts I 
ordered a few years back. I remember they were in Chicago.If I remember the 
blades have a compound angle and they didn't charge too much to do them over
Larry Brown

Beverly Shear MFG Corporation
3004 West 111th Street Suite 1, Chicago, IL 60655
phone: (773) 233-2063




At 04:29 AM 9/23/2005 -0300, you wrote:

>Anybody have any suggestions on sharpening a Beverly B3?
>
>Mine is leaving an annoying burr on 16 ga. m/s.  With feeler gauges I
>can see that there is about 0.002" clearance between the blades at the
>front and rear but in excess of 0.015 near the center of the blades.
>
>It's pretty obvious how you adjust the clearance given that the blades
>are right but it looks like my blades arent quite right.
>
>Do you suppose I could true it with a file if I took the blades out?
>Anybody ever done anything like that?
>
>I've seen a mention on the net of a Beverly website but I can't find
>it.
>
>Relevant wisdom, opinion or nattering welcome.
>
>- Mike
>
>--
>Michael Spencer                  Nova Scotia, Canada       .~.
>                                                            /V\
>mspencer at tallships.ca                                     /( )\
>http://home.tallships.ca/mspencer/                        ^^-^^
>
>--
>
>
>_______________________________________________
>Manage membership or unsubscribe at:
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith at hotmail.com
>password:  anvil
>___________