[TheForge] disc cutting?

[blacksmith at atlasok.com]

> Hi all,
>
> So, I've got a question:  Is there any easy trick to cutting a lot of
> disks?  Of various sizes?  In sheet metal.
>
> I tend to dish my own cups for candle holders[1] and such, and as a
> consequence, I need disks of various sizes.  I've looked a little, and I
> have found places that sell disks, but I don't care to spend several
> dollars for an ounce of steel.
>
> I've asked google, but the Oracle is not being very forthcoming.  Heh.
>
> Any thoughts?
>
> Thanks!
>
> Gabriel

Most welding supply retailers have a circle cutting attachment that will
hold yer torch tip and allow you to cut arcs and circles of various sizes
the one I found has allows for beveled cuts too. Not sure if it will fit
on the plasma torch.
course after you spend the time and consumables to cut and clean it better
off to find someone that is punching out holes and askin to haul off the
scrap.