[TheForge] Sorry to break in with a blacksmithing question

[Phil]

I'll be using tools under them as well.

--- Dan Tull <dantull at numail.org> wrote:

> Phil,
> I would NOT harden hot work tools.
> Remember H-13 is air harden.
> 
> 
> ----- Original Message ----- 
> From: "Phil" <mobjak at yahoo.com>
> To: "Sponsored by ABANA" <theforge at mailman.qth.net>
> Sent: Saturday, June 18, 2005 4:31 PM
> Subject: [TheForge] Sorry to break in with a
> blacksmithing question 
> 
> 
> I can't remember what I did before when attaching
> the
> dies to the mounting plates for a kinyon hammer. 
> I'm
> using H-13 for the dies.
> 
> Should I weld the dies to the mounting plates, and
> then harden and temper them, or harden and temper
> the
> dies, and then weld them to the mounting plates?
> 
> Once again, sorry for breaking in with a
> blacksmithing question.
> 
> 
> 
> ____________________________________________________
> 
> Yahoo! Sports 
> Rekindle the Rivalries. Sign up for Fantasy Football
> 
> http://football.fantasysports.yahoo.com
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com