[TheForge] cutting 1/4 copper

[Grover Richardson]

Hmmm.  140 VDC, 40 Amps.  That's enough to fry a monkey.  I didn't know it
was anywhere near that high.

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Kevin D
Sent: Wednesday, April 13, 2005 12:11 PM
To: Sponsored by ABANA
Subject: RE: [TheForge] cutting 1/4 copper


Grover,

Just looked this up on; http://store.cyberweld.com/milspec625.html  for a
MILLER SPECTRUM 625 PLASMA CUTTER


Quick Specs: Spectrum 625
Rated Cutting Capacity Rated: 1/2 in (13 mm)
Quality: 5/8 in (16 mm)
Sever: 7/8 in (22 mm)
Rated Output 40 A at 140 VDC, 50% duty cycle at 40? C / 104? F Plasma Gas
Flow/Pressure 6 CFM at 75 PSI or 170L/min at 517 kPa Weight Net: 57 lb (26
kg)
Ship: 60 lb (27 kg)

Kevin