[TheForge] Re: Drilling jig

[PlumDon at aol.com]

In a message dated 4/4/2005 11:13:21 AM Eastern Standard Time,  
sunironworks at yahoo.com writes:

Ralph  suggested long enough to fit the whole
piece of rod in? Drill the angle  blocks where you want the holes, tack
or clamp the rod in the angle, clamp  the jigged piece in your vise, and
drill away--


I tried something like this but when I bent it into a circle some of the  
holes tended to roll away from center. Just as someone else suggested they  
might. I thought making a few of these high-wheeled bikes would be an easy  job! I 
hope I am able to get about $750 for them to cover my  time.