[TheForge] candle cups

[Chris Worsley]

Phil,

Roll the cup sides over end of piece of solid round held in vise, hold 
in place with tongs,  and tap bottom pre-drilled tab into position.
Ta-da!

Chris

Oh, hot, one heat.

Phil wrote:

>I usually make candle cups that I braze to the drip
>pans, but I want to make ones that get riveted.  These
>start out being "T" shaped, with the vertical part of
>the "T" as the tab with the hole that gets the rivet. 
>I have a few questions about this:
>
>1.  do you bend the cylinder first, or the tab first?
>
>2.  do you drill the hole in the tab before you bend?
>
>thanks
>
>Phil
>
>
>		
>__________________________________
>Do you Yahoo!?
>Yahoo! Mail Address AutoComplete - You start. We finish.
>http://promotions.yahoo.com/new_mail 
>_______________________________________________
>Manage membership or unsubscribe at:
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith at hotmail.com
>password:  anvil
>___________
>
>
>
>  
>