[TheForge] Drill Press replace the chuck

[Chris Kilpatrick]

Would it make any sense to swap out the spindles and keep the albrecht fit intact?


----- Original Message -----
From: "Mark A. Pesetsky" <pesetsky at Princeton.EDU>
To: "'Sponsored by ABANA'" <theforge at mailman.qth.net>
Subject: RE: [TheForge] Drill Press replace the chuck
Date: Wed, 20 Oct 2004 11:22:54 -0400

> 
> 
> 
> 
> I did this while replacing the chuck on a hand held drill. I managed to get
> the new one on but had to use loc-tite to keep it in place since I screwed
> up the threads on the retaining screw. Before the loc-tite whenever I tried
> to back a screw out it would just unscrew the chuck from the drill.
> 
> PS: I have a Jacobs keyles chuck on my Milwaukee hammer drill, and hate it.
> It's almost imposible to get it tight enough to keep it from slipping, and
> then I have a battle getting it loose.
> 
> Robert Ehrenberger
> Shelbyville, Mo.
> 
> 
> 
> I had th echuck off once before and replaced it and never had a problem...I
> have heard that the ALBRECHT is a dream to work with...I'll use it and if I
> don't like it I can always go back...But to have a $300 precision made chuck
> sitting in front of you as you battle with the stock chuck just drove me
> crazy!!
> 
> Thanks
> Mark
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 



It is I who formed the blacksmith, 
who fans the flame into a fire and
fashions a weapon fit for it's work.

-- 
_______________________________________________
Find what you are looking for with the Lycos Yellow Pages
http://r.lycos.com/r/yp_emailfooter/http://yellowpages.lycos.com/default.asp?SRC=lycos10