[TheForge] Fay & Egan Lathe manual

[Kevin Donahoe]

Thanks Steve, never checked out a newsgroup before, but I'll peruse it after
I figure it out for a while.  And thanks for the tip on etiquette, not
unlikely I'd have stuck my foot in it.  And I'm not really sure I could get
more spam!  Which I'm sure is a naive comment :) let the flood gates open!

Kevin

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net]On Behalf Of Steve Smith
Sent: Saturday, May 22, 2004 7:42 AM
To: Sponsored by ABANA
Subject: Re: [TheForge] Fay & Egan Lathe manual


As others have said, the manual isn't going to explain how things work,
more how to do adjustments, etc. The manuals I've seen really haven't
been worth much. Most of the adjusting is straightforward to figure out
if you have a general reference like the South Bend book.

A manual is a nice addition if you can get it inexpensively. Put a note
up on the rec.crafts.metalworking newsgroup. You'll have to read replies
there; folks don't take well to being told "please respond by email as I
don't read the group". rcm is a fairly well behaved newsgroup. Note,
however, that posting your email address in the clear (such as your
Identity in your mail program) will gift you with more spam.

Steve Smith

Kevin Donahoe wrote:

> All,
>
> A little help please ;)  I bought a 1930's vintage 17x54 Fay & Egan Lathe
> last month at an auction.  I'm a ways from getting it setup, due to total
> shop reorganization.  But in perusing the 'net for a manual that would
> explain how all the change gears work, I found  machinerymanuals.com.  I
> placed an inquiry with them and they kindly responded that they did, in
> fact, have what I'm looking for... $200 + $7.50 s/h and they will send a
> photocopy with the original for a paltry additional $35, if I order it at
> the same time.
>
> The only other Fay & Egan lathe info I've been able to find are wood
lathes,
> shapers, planers, etc.  Anybody have any brilliant insights into getting
by
> for less jack?  It might be a nice cold winter nights project to calculate
> the gear ratios/thread feeds, hahaha, arrgh!  A client of mine mentioned
the
> Smithsonian might have such...?
>
> Regards,
>
> Kevin Donahoe
> Flying Pig Forge
> Morrow, OH 45152
> flyinpig at go-concepts.com
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________