[TheForge] picket spacing

[gblacksmith]

Andy:  Typically, codes state that the gap must not exceed four inches.
Grant
----- Original Message ----- 
From: "Gladish Family" <gladish at cnw.com>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Tuesday, July 20, 2004 6:36 PM
Subject: [TheForge] picket spacing


> Been a while since I've done this...is the common rule for picket spacing,
> "4 inch sphere can't go through" or "4 inch space is ok"?
> Building a rail where 5" spacing with 1" pickets would be just ducky...but
> will precisely 4 inch gap be able to pass?
> Thanks!
> Andy G.
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>