[TheForge] vent hood

Sat Jan 3 09:46:01 2004

If you leave a bit of a gap around the insulated pipe it sounds good.
What else is tapped into the chimney?

Mike Graf

Steve Smith wrote:
> I need to do this also. I'm planning on coupling the hood passively to 
> an external chimney. Based on what others have done for their coal 
> forges, I'm using 10" single wall pipe spaced 18" from any wood. I've 
> got a piece of insulated pipe to go through the wall. No exhaust fan.
> 
> Steve Smith
> 
> Wayne Ackman wrote:
> 
>> I need to build a vent hood over my gas forge.  I was wondering if it 
>> would require a exhaust fan in the pipe to pull the CO out.  If so, 
>> what kind of CFM does it need to draw?
>>
>> Does it make any difference if I take it thru the roof and thru the wall?
>>
>> design suggestions are most welcome.  :-)
>>
>>
>> Wayne
>> _______________________________________________
>> http://mailman.qth.net/mailman/listinfo/theforge
>> theforge mail list group photo site is
>> http://www.photoaccess.com
>> Login:  [email protected]
>> password:  anvil
>> ___________
>>
>>
>>
> 
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
> 
> 
> 
> 
> _____________________________________________________
> This message scanned for viruses by CoreComm
> 
> 

-- 
  Please visit us at http://www.gaudeteforge.com/