[TheForge] Re: 1018

[Andy Vida]

"Mark A. Pesetsky" wrote:

> What I have is a piece of steel that is 7" Diameter X 12" Tall. I am
> thinking of getting a piece of pie that the round ill fit in and weld it ti
> some I beam supports to hold the anvil in place. Then I will close the weld
> between the anvil and the pipe (O) like such.
> 
> Thanks for all of the input thus far guys.

	Not sure what you're describing here, but the anvil really should
	be solid all the way to the base of the hammer.  If you're intending
	on mounting the round anvil atop and Ibeam support, I would have to
	say that it's not the best solution.  If that's not what you're
	saying, then never mind.