[TheForge] Re: Advice? Air hammer die and anvil fit-up

[Larry and Pat Brown]

Would cutting the shoulder back on the die be an option?
L Brown


At 07:38 PM 7/12/2003 -0400, you wrote:
>Charles, If you could get the bottom of the die section flat........then
>shimming is an easy task.  You could even drill and pin in a new bottom for
>the 1/16 to 1/8 you'd be removing to allow a single steel shim to be used to
>bring the die to correct height and not have dovetail problems on the
>shoulders.
>
>Ralph