[TheForge] Re: antique machines and thoughts

Mon Jan 20 10:05:01 2003

Sorry, that was to be "Chuck or Athena."  Seems all my "or's" came out as "of"
in this message.

Larry

DragonsWatch wrote:

> My question is will you have the control of sensitivity required to not
> break blades?  I have a friend that does a lot of piercing work, you can see
> some at:  http://www.highlandanvil.com/ .  Once when I asked about using a
> scroll saw to cut out the pieces, I was told that it did not work due to
> breaking of blades.  If you contact Chuck of Athena they my have some advice
> on this subject.
>
> Larry
>
> Bob Evarts wrote:
>
> > > my scroll conversion would require that the sewing head to modified.
> > > two machines it would be reversable,
> >
> > just remember that sliding sheet metal around might mar the work surface
> > significantly and hurt the value, even it you convert it back.
> >
> > Bob Evarts
> > Forging a good life from the raw material of time
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________