[TheForge] Sidearm Burner Parts - orifice sizes and comments

[DragonsWatch]

One thing to take into consideration is the shape of the tip in the air flow.
It will effect the swirl and therefore the mix of the air fuel.  If you have a
tapered tip it will cause less disturbance than say a pipe cap with a hole in
it.

Larry

"terry l. ridder" wrote:

> hello;
>
> it had not occurred to me before but the sidearm i built is using either
> a 0.030 or 0.035 mig tip. these equate to 69 and 65 orifice
> respectfully. the reil burners i still run are running with a 57
> orifice (hand drilled).