[TheForge] Pulleys
DragonsWatch
[email protected]
Fri Feb 14 22:01:02 2003
Thanks Cameron, this is exactly the one. And yes I do think you responded
before. Must have been in the mail lost in the great crash of '03. ;-)
Larry
Cameron Stoker wrote:
> I think you are talking about my #50 Little Giant. There is a photo of
> it on the photoaccess site, on the third page of the tools and tooling
> section.
>
> I got the belt and pulley from mcmastercarr.com Here are part numbers:
>
> 6495K612 Timing Belt Pulley, H-Series, 1-1/2" Belt Wd, 2.80" Od,
> 16 Teeth
>
> 6086K846 Quick-Disconnect Bushing, Style Ja, 1-1/8" Bore, 1/4" X
> 1/16" Keyway
>
> 6484K28 Endless Rubber Timing Belt, 1/2" Pitch, Trade #510H, 51"
> Outer Circle, 1-1/2"W
>
> After several months of use, I have to say this set up is beautiful. I
> used to have a canvas belt with steel belt 'alligator' lacing on it and
> it would slip off at the worst times. Plus there was the annoying slap
> slap slap noise of the lacing hitting the pulleys.
> The timing belt never slips, is very quiet, etc.
>
> On Friday, February 14, 2003, at 08:25 AM, DragonsWatch wrote:
>
> > I think I asked this before, but can not find it or any replies.
> > Somewhere here I saw a picture where a tooth belt was used to drive a
> > LG hammer. Does anyone know of a source of these belts and pulleys?
> >
> > Thanks,
> >
> > Larry
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login: [email protected]
> > password: anvil
> > ___________
> >
> >
> >
> Cameron Stoker
> Stoker Forge
> [email protected]
> pgp key @ http://keys.stoker.net
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login: [email protected]
> password: anvil
> ___________