[TheForge] Pulleys

Fri Feb 14 16:16:01 2003

I think you are talking about my #50 Little Giant. There is a photo of 
it on the photoaccess site, on the third page of the tools and tooling 
section.

I got the belt and pulley from mcmastercarr.com Here are part numbers:

       6495K612 Timing Belt Pulley, H-Series, 1-1/2" Belt Wd, 2.80" Od, 
16 Teeth

       6086K846 Quick-Disconnect Bushing, Style Ja, 1-1/8" Bore, 1/4" X 
1/16" Keyway

       6484K28  Endless Rubber Timing Belt, 1/2" Pitch, Trade #510H, 51" 
Outer Circle, 1-1/2"W

After several months of use, I have to say this set up is beautiful. I 
used to have a canvas belt with steel belt 'alligator' lacing on it and 
it would slip off at the worst times. Plus there was the annoying slap 
slap slap noise of the lacing hitting the pulleys.
The timing belt never slips, is very quiet, etc.

On Friday, February 14, 2003, at 08:25 AM, DragonsWatch wrote:

> I think I asked this before, but can not find it or any replies.
> Somewhere here I saw a picture where  a tooth belt was used to drive a
> LG hammer.  Does anyone know of a source of these belts and pulleys?
>
> Thanks,
>
> Larry
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>
				Cameron Stoker
				Stoker Forge
				[email protected]
				pgp key @ http://keys.stoker.net