[TheForge] Scroll maker

Thu Dec 18 01:53:00 2003

Im looking for something quicker than that, motorised....

----- Original Message -----
From: "magichammer" <[email protected]>
To: <[email protected]>
Sent: Thursday, December 18, 2003 3:21 PM
Subject: Re: [TheForge] Scroll maker

> http://www.hossfeldbender.com/
>
>
> ----- Original Message -----
> From: "Shannell Sugrue" <[email protected]>
> To: <[email protected]>
> Sent: Wednesday, December 17, 2003 10:22 PM
> Subject: [TheForge] Scroll maker
>
>
> > I do a lot of scrolls in 10mm (3/8) round. Im thinking of making a
machine
> > to do the scroll part. The ends are flattened under the power hammer
then
> I
> > heat the length up , about 18 inches and bend it around a jig, its got
> about
> > 630 degrees in it, a full 360 then 270 more. Has anyone seen plans on
the
> > net, or built their own? I have some ideas but its always easier to copy
> > something that you know works. Id probably do this hot still. I have a 1
> HP
> > motor spare but no reduction gearboxes on hand, or was thinking maybe I
> > could use a pneumatic ram. Any suggestions?
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://www.photoaccess.com
> > Login:  [email protected]
> > password:  anvil
> > ___________
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>