[TheForge] Scroll maker

Thu Dec 18 00:54:00 2003

http://www.hossfeldbender.com/


----- Original Message ----- 
From: "Shannell Sugrue" <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 17, 2003 10:22 PM
Subject: [TheForge] Scroll maker


> I do a lot of scrolls in 10mm (3/8) round. Im thinking of making a machine
> to do the scroll part. The ends are flattened under the power hammer then
I
> heat the length up , about 18 inches and bend it around a jig, its got
about
> 630 degrees in it, a full 360 then 270 more. Has anyone seen plans on the
> net, or built their own? I have some ideas but its always easier to copy
> something that you know works. Id probably do this hot still. I have a 1
HP
> motor spare but no reduction gearboxes on hand, or was thinking maybe I
> could use a pneumatic ram. Any suggestions?
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>