[TheForge] Re: [TheForge]PULSE ARC

[Kenny O.]

Peter Fels And Phoebe Palmer wrote:

> As per your table I cranked my BlueGlue200's voltage setting full on 
> and set the IPM to about 50 using .035 wire and mostly got spray 
> transfer. Still some spatter but way better penetration... I sure 
> wouldn't want to do it overhead in a speedo.
> Have yet to try the pulse setting. Any feedback as to where it should 
> be set?
> Pete F 

As far as pulse arc is concerned you need a square wave , High Frequency 
type machine.
With Lincoln welders there is usually a dial control (it is built into 
the control board).
With the "True Blue" at least the not so new ones, there is an external 
pulse control system.
It looks like a calculator from 1970. Thermal Arc or thermodyne has the 
external controller
also. If you own a machine  but don't have the control system  you  will 
need to contact a dealer
to manipulate your settings. And that's all I know for now. I hope this 
helps, let me know if there is any other questions. I'm sure I can find 
an answer.