[TheForge] 36" diameter ring

Wed Aug 6 19:27:01 2003

Nope, not if you had a real short throw to the crossarm and it was 
inside the diameter of the piece you were bending. You might have to 
remove the vertical handle, but that is doubtful. (Remember Grasshopper, 
that the crossarm is adjustable by placement on the screw shaft, and the 
stop.)
You are correct if the press has a wheel.

Chris
Alexandria VA

Phil wrote:

>How about a six pack?
>
>The height of the wheel/arm would be the limiting factor.
>
>Phil
>
><snip>
>  
>
>>I liked
>>Phil's comment to do it on a flypress, it would give very consistent nudges.
>>perhaps could actually calculate the spread of the stationary posts and the
>>depth of the moving post with a drawn radius, give or take a little for the
>>spring of the cold steel.  Know anyone willing to experiment with their
>>brand-newly acquired flypress for the cost of a beer???? Lemme know ;)
>>
>>Kevin Donahoe
>>Flying Pig Forge
>>Morrow, OH
>>[email protected]
>>    
>>